![]() I would've expected the switch to operate the fan/light the same way, meaning instead of chains, you would control the fan/light functions with the remote but if you turned the wall switch off the fan/light would turn off completely until the switch was turned back on. Even if the wall switch is off you can still control the fan/light. The only thing that controls the fan/light is the remote. The new fan/light does not respond to the switch at all. I did hook up the black wires and white wires but the fan did not work. Since I dont have a blue wire from the fan to connect to the red wire, what do I do with the red wire. The junction box has black, white, and red wire. If you turned the switch off, it cut power to the unit altogether. The new ceiling fan from harbor breeze with remote only has a black and white wires. ![]() ![]() Once the switch was on, you could pull the chains for the light and the fan to adjust speed. The previous unit used a wall switch to power the unit. The new fan has a remote unit that connects to the fan first with only a white and black wire exiting the unit. There are 4 wires inside the box (Red, Bare, Black, and White) It was wired as such: Box Fan ![]() There was an existing fan/light in place. I've installed several fans and never had a problem. Using a step stool or ladder if needed, remove the canopy screws from the fan’s canopy using a Philips screwdriver. And of course, sometimes the remote gets lost on the couch, too.I installed a Harbor Breeze ceiling fan/light with a remote control unit earlier this evening. Turn the power to the electrical outlet box off. Not everyone puts it back in the spot that it should be, either. The fan controls generally include forward, reverse, and speed controls which are slow, medium, and high.Ī fan remote is often the most misplaced accessory when it comes to ceiling fans, because like a tv remote, many people in the home may use it. This remote will control both the fan as well as the light kit that is attached to the fan. Here we have posted a replacement remote. If you know how to use a multimeter to check the circuit, try doing that as well. See if there are any connections that have come loose. Once the power is completely shut off, open up the fan housing and take a look inside. Make sure before you do any work to the internal wiring of the fan, that you shut off power to the fan from the circuit breaker (not just the light switch). You’ll need to open up the fan housing and check the electrical connections. The same goes if there is power and the fan still won’t turn at all. If there is no power coming to the fan lights and there seems to be no power at all, there could be an electrical short within the fan housing. If the fan looks like it’s trying to turn and there’s a bad groaning sound, or smoke, turn the fan off immediately. Try putting it in forward and reverse to see if either mode works. Make sure the switch isn’t in between positions. If the fan won’t turn on and the lights are working, then there is no power to the fan. they need to be set the same way on both the fan and the remote. This can usually be done by checking the dip switches. If the remote is sending a signal, check to see if the fan and the remote are set to the same frequencies. Is there a light that normally turns on when you are using the remote to send a signal? Is the light still turning on or not doing anything at all? If the light is not coming on then the remote is not sending a signal.Īlso Check: How to use Harbor Breeze ceiling fan remote? If replacing the batteries does not work, check the remote. Replace them, even if you replaced them already recently. The batteries are the most common place to start.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |